26-10-2021, 10:23
27-10-2021, 12:14
Steering System - General Information - Power Steering System Filling and
Bleeding
General Procedures
1. Check that fluid level is at maximum level.
2. Run engine to normal operating temperature.
3. Recheck reservoir fluid level, top up if necessary.
4. NOTE: Maintain maximum fluid level in reservoir. Do not
increase engine speed or move steering wheel.
With engine at idle speed, slacken bleed screw. When fluid
seeps past bleed screw re-tighten screw.
5. Check fluid level.
6. Clean fluid from around bleed screw.
7. Check hose connections, pump and steering box for fluid
leaks by holding steering on full lock in both directions.
CAUTION: Do not maintain this pressure for more than 30 seconds in any one minute to avoid overheating fluid
and possibly damaging seals.
8. Carry out road test.
9. Check and top-up fluid level.
![[Image: defender239.png]](https://workshop-manuals.com/landrover/defender300tdi/defender239.png)
Selkiskö?
Bleeding
General Procedures
1. Check that fluid level is at maximum level.
2. Run engine to normal operating temperature.
3. Recheck reservoir fluid level, top up if necessary.
4. NOTE: Maintain maximum fluid level in reservoir. Do not
increase engine speed or move steering wheel.
With engine at idle speed, slacken bleed screw. When fluid
seeps past bleed screw re-tighten screw.
5. Check fluid level.
6. Clean fluid from around bleed screw.
7. Check hose connections, pump and steering box for fluid
leaks by holding steering on full lock in both directions.
CAUTION: Do not maintain this pressure for more than 30 seconds in any one minute to avoid overheating fluid
and possibly damaging seals.
8. Carry out road test.
9. Check and top-up fluid level.
Selkiskö?