05-11-2016, 09:32
Setting the Air flow sensor. Applicable to NON catalyst cars only. Using a voltmeter between red and black wire and blue and red wire check the voltage with the ignition on, but the engine not running. Recessed Hex head screw allows you to set the carbon monoxide base line with these voltages. NOTE these are base settings ONLY. Turn the adjustment screw clockwise to richen the mixture, and anticlockwise to lean the mixture. The screw has multiple turns, that will go from 0 volts to over 3.5 volts.

WWW
Haku
Jäsenet
Kalenteri
Apuja
Portaali
