Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Viitosvaihde ei mene päälle ( Defender 300Tdi vm.1996)
#6
It's one of those things where until the problem REALLY shows, it can be difficult to tell what is causing it to happen.

If the clutch hydraulic system is faulty, it usually will not get better until you actually do something to it; top up fluid, bleed air out, fix leak etc.

The other things that I'd suspect with the R380, not in any special order would be:

1. Bias plate on top of the selector turret is not adjusted or worn, or worst case about to break. This is common enough on R380 and LT77 boxes, but doesn't usually show those symptoms. It CAN make it difficult to select gears, usually all, but could in theory affect 5th and reverse I guess.

2. Just like above, the cast selector 'turret' which houses the pivot ball can wear, quite badly in some cases. The steel pin through the pivot ball ofter wears the vertical slots in which it locates, especially where it sits 'idling' for a long time in 5th gear. This can actually make selection troublesome at times.

3. MTF94 oil is specified for the R380 to help with poor gear selection and mid-driving shifts. Very often I've had to change out the ATF oil which has been put into R380's by mechanics at routine service time. The reason seems to be that Autodata and many other service reference guides (including for example Castrol reference books etc) show ATF IIID as the correct oil type, based on that being the case in 1994 when the R380 was introduced. This was changed pretty soon but it seems that oil suppliers don't really pay attention. It's not always needed, but check anyway. MTF94 is a kind of green/yellow oil and doesn't smell anything like ATF, which is usually red when fresh, or brownish when used/burnt.

4. If the clutch plate assembly and hydraulic system is working correctly, and the fault seems to be intermittent, you might have to suspect something isn't right with the clutch selector fork or release bearing. With the work involved to get in this far, I'd rule out everything else first.

5. Just to complicate things, don't forget that just because the clutch slave/master isn't leaking or showing any signs of a physical fault, it doesn't mean a seal isn't faulting and partially inverting/reverting. A new slave and master cylinder would rule those things out but if you go to the trouble, make sure it's a good quality. If it comes in a Blue Box, put it in the bin and order again!

Again, sorry for the English reply. Maybe one of these days I'll sit down and study Finnish in the evening. Today the postman brought a copy of Tom Sheppard's Vehicle Dependent Expedition Guide, so the Finnish study will have to wait until another day. ;-)
Reply


Messages In This Thread

Possibly Related Threads…
Thread Author Replies Views Last Post
  Defender 90 1996 tarvitsee uuden takapalkin. Vane 1 5´005 28-05-2021, 12:08
Last Post: timo999
  Hätä: Defender TD5 ei mene vaihteelle... Setok 17 12´758 18-12-2012, 10:20
Last Post: rantataimen
  Defender 110 STW 300Tdi solihull 15 11´004 01-11-2010, 02:17
Last Post: arska

Forum Jump:


Users browsing this thread: 2 Guest(s)